Need Support? Let’s guide you to the right answer or agent.

SYNCHRO Ideas Portal

ADD A NEW IDEA

Models | Tools

Showing 14

Cross Section Auto Annotation

The cross section tools in Field have limited use, especially to non-designers. Some sort of auto-labeling (ideally of slopes, elevations, material types for meshes, etc.) that could be toggled on and off would be extremely helpful.
Ariel Froerer 16 days ago in Field / Models | Tools 0

Properties selection

Currently you can only select 1 item and identify properties in the model. When selecting more than 2 items, even if they are apart of the same system, the model is unable to give the properties. Would you be able to adjust this feature so that yo...
Helen Whitcher 8 months ago in Field / Models | Tools 1 Future Consideration

When using the Station/Offset tool keep measuring until done

Right now when using the Station/Offset tool you have to pick the alignment after every time you use it. It should just keep letting me snap Station and Offsets down the alignment until I'm done.
Dan Sheldon over 1 year ago in Field / Models | Tools 0 Future Consideration

Switch between Element and Alignment in Field app (Station Offset Tool)

It would be helpful to have the option to switch between element and alignment while using the station offset tool in the field app (Similar to Control - see attached)
Thomas Schimpf over 1 year ago in Field / Models | Tools 0 Future Consideration

Search within the model for element by name

Users often face difficulty in finding specific elements within a complex model due to the large number of elements present. Thus, they need a way to search for elements within the model by using a text-based search. If such a feature is available...
Jonathan Cunningham 9 months ago in Field / Models / Models | Display / Models | Tools / Models | Views / Models | Visibility 0 Planned

Civil tools - Selection at location

When in the field and using the geolocation feature in the Field app. It would be helpful and more efficient if the software could create automatic cross-section views at your current location on a split view type of setup. Walk up and down the ro...
Thomas Schimpf over 1 year ago in Field / Models | Tools 0 Future Consideration

Add setting option to change "Scope" from Element to Top Assembly

In Synchro Control, we can set the scope to "Top Assembly", which allows us to select part of a cell (from ORD/microstation) and the Properties tab will display the full parent element properties, which is where we have item type data attached. In...
Guest 5 months ago in Field / Models | Tools 0

Cross section selection tool on other views

It can be hard to select lines, items or layers in congested areas of the model. Especially when you have big ol construction fingers. It would be very helpful if the Cross-section selection tool was available on all views for easier model selecti...
Thomas Schimpf over 1 year ago in Field / Models | Tools 0 Future Consideration

Could additional snap modes be added in Field model tools

Could you add Intersection, Center, and Midpoint Snaps to SYNCHRO Field model viewing?
Dan Sheldon over 1 year ago in Field / Models | Tools 3 Future Consideration

Incorporation of an "Undo" feature within the measurement tool

incorporate an "undo" button while you are using any of the civil tools. For example, being able to use the "station/Offset" tool 10 times and only "undoing" the last 3 measurements taken instead of all the 10.
Tony Bonacorsi about 1 year ago in Field / Models | Tools 1 Future Consideration